• Ride-On TPS (Tire Protection System) is a tire balancer and sealant compound for tube or tubeless tires that evenly coats the inner surface of your tires

• Eliminates the need for wheel weights, specially formulated to hydro-dynamically balance high speed tires, dampen road noise and vibrations that cause a rough ride

• If the tire is punctured in the contact patch, the centrifugal force of the rotating tire and the internal air pressure force Ride-On into the hole, sealing it instantly

• Ride-On is a Green biodegradable product that is designed to be non-hazardous and non-flammable, and contains corrosion inhibitors that protect all alloys of steel, aluminum, magnesium and yellow metals against oxidation

• Note: Refer to Dosage table/calculator to find the amount needed for each tire

• Ride-On TPS will act as a balancer and will result in erroneous readings from a dynamic spin balancer

• Available in motorcycle and ATV formulas, simply squeeze/pump the fluid into the tires and you are set to go, refer to dosage table below to find the amount needed for each tire

IMPORTANT NOTE:After installing Ride-On TPS Motorcycle Formula sealant into the tires, a slight vibration may be noticed until the sealant has warmed up and distributed evenly in the tires. This process usually takes 2 to 5 miles. DO NOT attempt to rebalance tires after the installation of Ride-On TPS Motorcycle Formula. Ride-On TPS is a balancing compound

Ride-On dosage (all measurements in inches):

High speed street tires: Diameter x Width x .055 = ounces of Ride-On

Off road tires: Diameter x Width x .075 = ounces of Ride-On

ATV tires: Diameter x Width x .087